Three-Servo Flow Wrapping: Where the Extra Speed Comes From
Release Time:
Nov 21,2026
Every flow wrapper does the same four things: form a tube from film, place the product inside, seal the ends, and cut. The difference between 300 pieces per minute and 1,300 pieces per minute is not a bigger motor. It is how many of those four motions are independently controlled.
The Haitel A1200 three-servo high-speed candy flow packer runs 1,000 to 1,300 pieces per minute. The three-servo architecture is the reason.
What a servo changes
A mechanical wrapper drives all motions from one shaft. Every motion is locked to a fixed phase relationship, which is reliable and fast to build but inflexible. Changing the product length means changing gears or cams.
A servo wrapper gives each critical motion its own motor and its own program. The film feed, the end sealer, and the cutter can each follow a motion profile. That means the machine can slow the film during sealing and accelerate between products, which is where the time savings come from.
Three servos is the point at which the critical motions are all independent: film feed, sealing jaw, and cutter. Below that, one motion remains mechanically linked and limits the achievable profile.
Why speed is really about dwell time
Sealing requires heat and pressure applied for a minimum time. That dwell time is fixed by the film, not by the machine. Faster machines do not seal faster. They spend less time on everything that is not sealing.
That is the key insight for buyers: at high speed, the machine's job is to compress all non-sealing motion into a smaller window. This is achieved through motion profiles and through reduced moving mass, not through force.
Specifications at a glance
Parameter | Value |
Output | 1,000 to 1,300 pieces per minute |
Drive architecture | Three servo axes |
Independent motions | Film feed, sealing jaw, cutter |
Product scope | Candy and small confectionery pieces |
Practical limit | Film seal dwell time, not machine speed |
Four checks for a high-speed line
Can the upstream line feed 1,300 pieces per minute evenly? A wrapper running at 1,300 with irregular infeed performs worse than one running at 900 with a steady stream.
Does the film support the speed? Thin films seal faster; thick or laminated films may not hold at the top of the range.
How is a missed product handled? At high speed, gaps are normal. The machine should handle them without film waste.
What is the noise level at rated speed? This is often omitted from specifications and matters for operator fatigue over a full shift.
Frequently asked questions
Is a three-servo wrapper harder to maintain? It has more electronics and fewer mechanical linkages. Maintenance shifts from mechanical adjustment to diagnostics, which requires different training.
Can it run at lower speeds for small batches? Yes, servo machines are more flexible across a speed range than mechanical ones.
Do I need 1,300 pieces per minute? Only if your upstream line produces that much. Buying speed you cannot feed is buying idle capacity.
The next step
Measure your actual infeed rate over a full shift, including stops. If the average is well below the wrapper's rating, the constraint is upstream and a slower wrapper would deliver the same output for less money.
Related reading: balancing a high-speed packing line, and cut and flow wrapping for two packaging styles.
Keywords:
More information